Tag Archive: NE5532


Image
 Among the final amplifier we called. Regional Power Amp, will it work on several well-known as Class A, Class B, Class AB etc. Each class of the above, to honor the Class A was superior to the sound quality. best. However, class A power output to a low of 20 percent compared with a loss of power or the power consumption of about 5 times the power output. Therefore, the problem of heat Although it has not paid any audio. But anyway, despite the low-watt power, it also provides crystal clear sound quality than Class B and Class AB.

      Principles of integrated amplifier class A is IC1 – NE5532 to extend signal input through the C1 to increase 15-fold. The signal output from the pin 1, signal hemisphere positive through C2 to access Q1-BD139 and Q3-2N3055. is powered by Darling ton, amplifiers and signal the intensification of the negative side of C3 through the amplifier with the Q2-BD140 and Q4-MJ2955. This is the Darling ton, too.

Then the output signal from the positive side of the pin E of the Q3 and the negative side of the pin out of the E in Q4 through R10 and R11, to prevent short circuits and then output to the speakers. This will power up to 5 watts. The D1-D4 acts as a rectifier in the DC bias for Q1 and Q2. And VR1 is adjusted to a constant current bias is at work. The Q1-Q4 will be attached sheet cooled, Q3 and Q4, especially the thermal plate must be large. Because the circuit has high energy loss.

Image

This circuit Tone Control Stereo you can ajustable bass , mid range and treble. It use IC NE5532.
Supply Volt min 12V 80mA. Easy to build, PCB small.