Among the final amplifier we called. Regional Power Amp, will it work on several well-known as Class A, Class B, Class AB etc. Each class of the above, to honor the Class A was superior to the sound quality. best. However, class A power output to a low of 20 percent compared with a loss of power or the power consumption of about 5 times the power output. Therefore, the problem of heat Although it has not paid any audio. But anyway, despite the low-watt power, it also provides crystal clear sound quality than Class B and Class AB.

      Principles of integrated amplifier class A is IC1 – NE5532 to extend signal input through the C1 to increase 15-fold. The signal output from the pin 1, signal hemisphere positive through C2 to access Q1-BD139 and Q3-2N3055. is powered by Darling ton, amplifiers and signal the intensification of the negative side of C3 through the amplifier with the Q2-BD140 and Q4-MJ2955. This is the Darling ton, too.

Then the output signal from the positive side of the pin E of the Q3 and the negative side of the pin out of the E in Q4 through R10 and R11, to prevent short circuits and then output to the speakers. This will power up to 5 watts. The D1-D4 acts as a rectifier in the DC bias for Q1 and Q2. And VR1 is adjusted to a constant current bias is at work. The Q1-Q4 will be attached sheet cooled, Q3 and Q4, especially the thermal plate must be large. Because the circuit has high energy loss.